The projection lamp should be replaced when it burns out. It should only be replaced with a certified replacement part, which you can order from your local dealer.
Important
a. The projection lamp used in projector lamps can contain a small amount of mercury.
b. Do not dispose this product with general household waste. See below notice for recycling instructions
c. Disposal of this product must be carried out in accordance with the regulations of your local authority
Important recycle instructions:
Lamp(s) inside this product contain mercury. This product may contain other electronic waste that can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal Laws. For more information, contact the Electronic Industries Alliance at WWW.EIAE.ORG. For lamp specific disposal information check WWW.LAMPRECYCLE.ORG.
Warning: Be sure to turn off and unplug the projector at least 30 minutes before replacing the lamp. Failure to do so could result in a severe burn. The illustrations may differ from your product, and are meant as general examples. Please refer to user manual for accurate instructions on how to replace the projector lamp on your model.
1. Remove the single screw on the lamp compartment cover with a Phillips screwdriver.
2. Remove the lamp compartment cover
3. Remove the screws from the lamp module with a Phillips Screwdriver
4. Lift the module handle up
5. Pull firmly on the module handle to remove the lamp module.
6. Reverse steps 1 to 5 to install the new lamp module. While installing, align the lamp module with the connector and ensure it is level to avoid damage.
Note: The lamp module must sit securely in place and the lamp connector must be connected properly before tightening the screws.
7. Refer to user manual for instructions on how to reset the lamp life timer.
Manage consent to cookies
